|
|
|
|
|
The upgraded, easy to fill Vision V2 multi-wick system with 8 long wicks has 510/eGo threading. Same structure, material, and smooth, clean vapor production as the original Vision clearomizers. These cartomizers are designed to prevent leaking. Sold as a single unit, each with a customized screw on black drip tip.
Please choose the color and resistance. Please note: the red has a pink tone.
To choose the resistance
Lower resistance (measured in ohms) is the best for a strong throat hit and great vapor production when using a standard voltage battery or at lower voltage on a variable voltage battery. The low resistance coil heads will give a burnt flavor if used at too high of a voltage setting. For example, the 1.8 ohm coil wick heads will give this burnt flavor around 4.2 volts. It is best to keep below this voltage level.
Higher resistance (higher ohms) will produce a lighter throat hit and less vapor production at low voltages or will provide a stronger throat hit and more vapor production at higher voltages on a variable voltage battery. The higher resistance coil wick heads can be used for the full range of most variable voltage batteries.
For best results using variable voltage batteries, try starting at around 3.8 V and then increase the voltage for a harder hit or decrease for a lighter hit.
Threading: 510/eGo
Resistance:1.8-2.0, 2.1-2.4, or 2.5-2.9 ohms
QUICK START
Unscrew the black mouthpiece on the Vision V2 Clearomizer. Fill with e-liquid by slightly tilting the uncapped clearomizer to the side. Avoid the center metal post and fill with e-liquid nicotine to the 1.6 mL mark. Replace the mouthpiece, swirl the liquid around inside and allow it to sit for 2 minutes for the wicks to transport the liquid to the heating coil.
Refill the Vision Clearomizer with e-liquid nicotine as needed.
The Vision Clearomizer will perform well for roughly 1-3 weeks depending on frequency of use. Over time it will decline in performance and will need to be replaced.
Filling Instructions
* Unscrew the drip tip from the clearomizer
* Fill 1.4-1.6 mL of Elixir e-liquid nicotine from the side
* Do NOT pour the e-liquid into the airflow tube in the middle.
* Screw the drip tip back in.
* Please wait 1-2 minutes for the e-liquid to feed into the coil before vaping.
Please follow this link for the Replacement Mouthpiece for the Vision V2 Clearomizer.
*Please note: This cartomizer should not be used with Cinnamon Death, Rage, Heaven & Hell, Sweetart, Ectoplasm, or Gummi Bear.
*No warranties / refunds / exchanges on cartomizers.
